A really nice combination square.I have a few Faithfull tools. I particularly like their blades for jigsaws etc. They are always good quality and are built to be used.This combination square is no exception. It's part of their Prestige range.Build wise, it's very nice. It's all made from aluminium. With the adjustment knob and the scribe in the bottom, being made from brass.It has a vertical spirit level in the handle, which when measured against my Stabila level, was bang on.Where this square really stands out is in the measure.There is nothing easier to read than white characters on a black background.The markings are very crisp and precise.When compared with the standard black numbers on a steel measure, the difference is remarkable.The ruler has cm and inch marking on both sides, with the direction of the numbers being reversed, so you can have the flat edge of the handle start at 1cm or 30cm.Both ways have their uses, so having the option is great.A note on removing the ruler. It's held in place by the brass tightening knob.There is a little 'hook' at the top, and this slides into the groove on the ruler.It can be a little tricky at first, but once you've lined it up correctly, you shouldn't have any issues.The handle has a long side for 90 degree measurements, and also an angled back, for 45 degree or 135 degree measurements, depending on which way around you have it.Dont forget about the little brass scribe in the bottom. So many people never know that this is there. It's not always what you need, but it will come in handy on occasion.Overall, this is another great Faithfull tool.It is solidly made, and works well in use.Where it really stands out though, is in the legibility of the numbers on the ruler.It really is easy to see, even in subdued lighting conditions.I hope you found this review helpful.

Works smooth, accurate and very light which can be good or bad depending on your outlook.2 things I would change however is for the numbers to start at the same end on each side, again some like that and some don't. Personally it's how I prefer it.And the second would be to get rid of the hole on the one end. It basically makes one end useless as the slot falls through it and onto the floor. Which wouldn't really be as much of a issue if the numbers started at the same end on both sides.Looks like the 150mm one doesn't have the hole thankfully.Otherwise it's my go to pretty much everytime.

Topartikel, sehr genau, lässt sich super einstellen. Würde ich immer wieder kaufen, super Preisleistung

Kurzfassung: Alle Maßangaben bzw. Winkel sind korrekt.Zumindest kann ich das auch nach mehrfachem verstellen des Lineals durch die Umschlagprobe bestätigen für den 90° Winkel.Auch der 45° Winkel scheint stimmig zu sein. Hierzu habe ich ein Linie in 45° aufgetragen und die Katheten gemessen. Diese waren gleich lang.Ebenso ist auch die Maßangaben (mm-Skala) korrekt.Alle Kanten gut verarbeitet - es gibt keinen Grat woran man sich verletzen könnte.Somit ist es für mich ein super Produkt zu einem fairen Preis.

I had a previous combination square and because of the way it works they aren't always square.This is perfectly square and feels like a quality item.