Winkelwagen is nog leeg.
Winkelwagen is nog leeg.Productbeschrijving
Eigenschappen: materiaal: M42 sneldraaistaal. Diameter: 150 Schachtdiameter: 10 mm Diepte boorgat: 2-35 mm Pakket inbegrepen: 1x HSS-gatenzaag Opmerking: Gatenzaag voor gebruik, zorg ervoor dat u redelijk grijpt, keuze, controle, toerenteller en continu toegevoegd aan het koelmiddel, om te voorkomen dat de randen barsten, zoals de hogesnelheidspistoolboor die in de bewerking wordt gebruikt, moet de schakelaar dus openen en sluiten om de snelheid te minimaliseren.
In my opinion,
10 augustus 2025
I would urge you to look past this product and spend a little bit more. Using this to cut half a hole in 22mm thick softwood (which it failed) has burnt out my expensive Makita drill. To begin with, the construction is 1.5mm thick steel which results in a holesaw/drill bit that weighs 2lbs, or 915 grammes. That is an incredibly heavy load to put on a standard drill, which puts a lot of strain on the motor and once it has got up to speed, the weight requires a lot of stopping, which will harm your drills brake. There is no cutting edge to the saw, just points to the teeth which soon wear down. You can see from my pictures that there is no sharpening or off-set to the teeth. I couldn't cut through the 22mm softwood board (and I was only cutting half the diameter). My drill has burnt out. Dead. Save yourself the same headache and buy better quality.
Valérie
28 juni 2025
Idéal pour faire des trous régulier, je conseille
Francesco 1973
1 juni 2025
Ottimo prodotto per il lavoro che dovevo fare.Il diametro del taglio è 150mm precisi, anche se a me la precisione poco serviva.Consigliato.
Oligra
30 april 2025
Sieht stabil aus
Tito
2 december 2024
Ok
Aanbevolen producten
Misschien vind je dit ook leuk