Redrex Gladde PTFE slang bowden tube voor 1,75 mm met snijapparaat, 2,5 mm IDx4 mm OD lengte 5 m compatibel met Bambu Lab A1/A1 mini/P1P/P1S/X1C, K1/K1 Max/Ender 3 V3 3D-printer (transparant)

bambulab a1 miniで使用。フィラメントは確かに通るがチューブに柔軟性が無く硬いため、フィラメントの送り出し最中にチューブ内で抵抗がおき、プリンターの方で送り出し異常が検出される。チューブをbambulab純正のチューブに帰ると正常に印刷出来たので、このチューブが良くない。購入される方は注意。ただ、付属のチューブカッターに関しては切れ味や真っ直ぐ切るサポートなど扱いやすいため、実質チューブカッター代と思った方が良い。

Perfect! Fit my A1 mini perfectly. The tube is more transparent than the stock version, so that's a bonus.

La descripción indica que se incluye el cortador pero no es así.

I recently purchased a P1S combo and an extra AMS unit. I don't have a lot of space on my desk so I decided to mount both units on top of the printer but I needed extra PTFE cables to make everything work so I ordered this one as it was long enough and came with the cutter to make sure the cuts were straight. The first thing i needed was a bunch of little pieces to use inside the AMS unit to help prevent the filament from getting stuck as you can see on the first picture. Then i needed long pieces to connect the back of the AMS to the back of the printer and finally an extra piece to connect to the back for the external spool holder. This tube was more than enough and I have extra to spare. I have been using this new setup for a few days and haven't had any issues. The filament travels smoothly through all the connections and everything is printing as expected. It is kind of hard to go wrong with PTFE tubes are it is something very simple but, regardless, this one is working very well and I have extra in case I need more in the future.

Tube won't stay in fitting as the outside diameter is too small, the inside is also smaller causing restriction and stopping the filament from being pulled in by the extruder. Don't buy this, buy the original otherwise you will regret it