REEKON M1-kaliber-adapteromheining, maakt de montage van het M1-kaliber op een groot aantal verstek- en afkortzagen, aluminium bevestigingspunt mogelijk

Materials were very sturdy. There were no instructions but install was self explanatory. I recently bought the M1 and the quality is top notch

Excellent

Not quite universal. I have a Ryobi 7” miter and the right side of my miter (battery side) bumps on the fence when going down. I had to cut off about 2” from the top in order to make it work.Also, it’s a two piece design now so for whatever reason when I lined them center on the blade, they aren’t quite flat to each other so when you’re sliding material against the fence it’ll push it forward slightly. I did tighten the screws all the way in but you have to be careful as well because it’s mdf and even with the shortest screws it almost came through on the left part.That’s my experience with it so probably different with others since not everyone is using my miter but just a heads up. If the company made the piece one solid piece again and then had the right side of the fence lower than the right I think it would truly be universal.

Good Product

The adapter came in 2 pieces instead of 1 as shown in both the ad and the installation videos. It’s decent quality but it does not work with the Ryobi TSS702. The adapter was so tall that I was unable to make 45 degree angle cuts or put it all the way back because the blade protector would hit the adapter. It’s also pretty thick and took up almost 1/3 of the surface area that’s needed to slide my wood through. Unfortunately I have to return it and will have to make a bracket for my M1