Relaismodule AC100V-250V Schakelaar 0,5s-1000min Instelbare Oneindige Cyclus

Deze print werkt in het geheel niet!Er brand geen Led en er schakeld niets. (waardeloos dus)

Ottimo prodotto ha la poassibilità di regolare sia in attesa che in consenso i due timer per una alimentazione a 220 v in uscita. Già provato funziona benissimo.

Funktioniert einwandfrei erst Sekunden einstellen und dann MinutenBin voll zufrieden macht das was angegeben wurde hervorragend

Destiné pour une pompe de surface (trop puissante) qui pompe l'eau du forage (lentement généré) ne pouvant pas intégrer de flotteur/sécurité manque d'eau.Pour le moment il fonctionne. Par contre le réglage du potentiomètre (la minuterie) n'est pas fidèle à la graduation, mais avec un chronomètre sous la main on ajuste le réglage a la perfection. 4 plages de réglage c'est super. Jusqu'à 100 sec, jusqu'à 100 min, jusqu'à 1000 sec et jusqu'à 1000 min.Boucle infini, combien de seconde allumé et combien de seconde éteint, fonctionne très bien.Ne pas oublier le shunt ou l'interrupteur sur le domino interrupteur.

This is a good versatile well-made timer module. All connection information is shown on the circuit board. Packaging was a sealed anti-static bag, no box, which is not really sufficient.WARNING! The module is for use on mains, 240-volt AC. This is a potentially lethal voltage. If you are not a trained and competent person with good technical knowledge of electricity/electronics DO NOT purchase this module for your and others safety.Info: the module has MAINS Live and Neutral inputs. The neutral input is common to the neutral output terminal. The LIVE input is fed to the ‘common’ terminal of a ‘single pole two-way relay’.There are five terminals at one end of the board these are: Mains IN (L&N). the three remaining terminals are: Mains Neutral OUT and NC (normally closed) and NO (normally open) contacts of the relay.There are two terminals at the opposite end of the circuit board which are inputs for logic cycle reset, ‘Start and Stop’ – the terminals can have a push button connected or be shorted together for continuous operation.Timing settings are via a pot and two dip switches, identical for both ON and OFF cycles, ON being relay coil energized and the mains input is switched (closed circuit) to the NO output terminal of the relay. Or the mains output is interrupted (open circuit) on the NC terminal of the relay.There is a dip switch for setting between seconds and minutes and another dip switch to set between, 0-100 (seconds or minutes) or 0-1000 (seconds or minutes). The duration of ON and OFF cycles set by the dip switches are infinitely variable between the two possible cycle duration ranges of 0-100 or 0-1000 (second or minutes) - the variability is via a potentiometer, minimum duration 0.5 sec/ maximum 16.6 hrsA brief button push starts a ‘set’ cycle another brief button push will stop the set cycle. If the button push terminals are shorted the set cycle will continue indefinitely. Remember if you set a long cycle you will need to push the button twice the reset and start the cycle again (one push to stop – one push to start). If you repower the module the cycle will automatically restart from the beginning only if the reset push button terminals are shorted.Hope this explanation makes sense.

Funciono perfectamente, y es lo que yo necesitava, por lo tanto todo perfecto