SDM120D Single Fase, Elektrische Energiemeter, Elektriciteitsverbruik Monitor, 45 Amp kWh Din Rail Power Meter, Pulsmeter 1000imp/kWh. Digitaal LCD (GEEN Backlight Versie) Display. MID gecertificeerd/gekalibreerd

Deze is officieel goed gekeurd in mijn land.Deze heb ik mijn boot gemonteerd zodat ik kan controleren wat mijn verbruik is ..Maar ook dat ik de haven kan controleren.Met een notitie boekje houd ik bij wat word gebruiktAls ik van haven naar haven verplaatst.

Semplici economici direi perfetti

Producto según descripción y funciona bien.

tutto bene

Does what it needs to as a meter, and is a good fit in my installation. In my case that's in the consumer unit in an outbuilding that I wanted to know the specific electricity usage for.Fitting was OK, but per the photo I did need to bend the consumer unit's bus bar a little as the screw terminal locations in this meter were staggered relative to the standard MCBs to be fed from it. The screw terminals are of course also eccentric across the meter as there are two side by side in the 1U width meter, and they're also thinner than the bus bar was. Not insurmountable in this case, but perhaps a differing standard somehow.As far as the meter in use, it works perfectly (as far as I can tell for accuracy anyway) and has been very handy.

These units are easy to fit and give a good indication of the KWh consumed through them. They fit on the DIN rail but will require the live conductor lugs cutting off. The units have cable connections in and out. They are rated to 45amps, I’m using them in supplies rated to 40amps.