Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Securit A4 Portret Barrière Post Top Sign Houder - Goud

20,99€ 46,33€
Gratis verzending bij bestellingen boven 25,99€

Over dit item

  • ideaal voor het veilig weergeven van posters
  • gewoon de bovenkant van de barrière vastschroeven
  • bestand tegen vervaging, roest, krassen en deuken
  • Gemaakt van hoogwaardig materiaal


Barrièrepalen zijn de perfecte plek om een bord te plaatsen voor informatie of promotionele doeleinden. Het bord wordt eenvoudig op de paal geschroefd. Het bord biedt ruimte voor een A4-poster die gemakkelijk tussen twee transparante inzetstukken (meegeleverd) kan worden geplaatst. Ze zijn verkrijgbaar in een chroom, goud en roestvrij stalen afwerking.


Suchan
6 juli 2025
Way too expensive for very cheap material ..will not encourage to purchase it…
YEREMIAN
9 juni 2025
JE NE COMPRENDS JE N'AI RECU QUE LE CADRE AVEC LA VIS PAS LE PIED ????
MrskimmieS
18 april 2025
I searched the internet high and low for a product such as this to go with my already purchased gold coloured posts. I was so happy when I found these. I bought two and then an hour or so later decided that really I should have bought three so I purchased another but in the short space of time between ordering the first ones and then the extra one the price had increased ! (I wasn't best pleased).When they arrived they were fab (although one had a tiny dent in it, but I could live with that ... a tiny dent v the hassle of sending it back and all that)! The insides are perspex, good I thought as it saves the risk of the glass breaking. I made my sign for the inside on a single sheet of 80gsm paper and then put a perspex sheet on each side (It tells you to take off the protective covering on the perspex which I did as if I hadn't then you couldn't clearly read the notice) but when I slid it all back inside the frame, the frame edges are quite rough and it scratched all up both side of the lovely new perspex (again not ideal but again I can live with it .. but made a mental note to possibly buy thinner sheets of perspex).HOWEVER .... the next thing that went wrong I can't live with as it makes the whole thing unusable. I got to my event, put out my posts and ropes, unscrewed the gold ball on top of the first post, went to put my sign in and the screw on the bottom of the sign isn't wide enough to screw into its corresponding hold in the post, so it just slots in and flops about .... I couldn't believe it :( I didn't have time to improvise so I had to actually tell people which way to go as I didn't have any signs) !I really don't want to send these back as they were the only ones I found so now I have to find a way of making the screw bigger (fatter/wider) on the sign so it fits into the post properly. I don't want it to be permanent solution as I don't need the signs at every event and need each post to have a gold ball on it.Sorry for the long review. ...( but I thought I would give you the whole story lol) ! I so wanted to give it 5 stars but I knocked a star off for the tiny dent the scratching of the perspex and another star off for the screw being too small.
KHALKHAL Mohamed
23 november 2024
attention pas de pied alors cher pour juste le support
LE MONTET
9 november 2024
Les photos sont trompeuses car le poteau n'est pas livré! Ne sert à rien sans les poteaux