Está muy bien, lo uso conectado a mi homey pro, encía lo uso de puente bluetooth para el Shelly blu motion.Me mejora la conectividad del bluetooth y consigue que mi blu Motion tenga una respuesta inmediata.Tengo que comprar más de estos.

I've seen some of the other reviews and I'd like to add some information for those looking at this device.1. Both 12 guage solid and stranded copper wire will fit in the screw down clamps on this device, though you do have to turn the screws out almost completely.2. Seeing as how this is useful only till 16A, and the closest US circuit rated below that are 15A circuits which uses 14 guage wiring, you should use and stick with 14 guage wire, stranded whenever possible as to allow the most contact area under the screw clamp. Why stranded? Cause of the next point...3. Solid wire would only allow for 2 or 3 very small points of contact within the screw clamp (4 if you put the wire in at an angle or bend it in some way), as the screw clamp cannot be torqued down to try and flatten the round solid wire for greater contact area, even as "soft" as copper may be. These little screw clamps will NOT be able to take the torque that a screw on a regular receptacle would be able to take to mash down on a solid copper wire. Which is why I say stick with stranded to allow the wire to easily "form" to the cavity of the clamp to allow more surface area contact. Just make sure to recheck that the screws are tight after some heat cycles on the unit in that circuit. I need to emphasize that these screws really can't be torqued down much, and may loosen over time (heat cycles from circuit use) because you can't put too much torque on them.

Parece ser bueno, acabo de instalar. Puede ver en el futuro .....

Shelly es con diferencia el mejor fabricante de relés. Solamente falta que sea compatible con Matter (Según Shelly Gen3 en adelante lo será)

Alles ok gerne wieder