SONOFF ZBMINIR2 Zigbee Smart Switch, Zigbee 3.0 Licschakelaar, Zigbee Smart Switch, werkt met Alexa & Google Home, Zigbee Hub vereist, neutrale kabel vereist

très pratique

Fungerar utmärkt. Jag använder min för att styra utebelysningen och jag anslöt min direkt till Home Assistant med Zigbee och det gick på under minuten. Känns gedigen och fick utan problem plats i en kopplingsdosa.Nu fungerar lampknappen utan att förstöra min automation för att tända/släcka lamporna. Enda nackdelen jämfört med trådlösa alternativ är att den kopplas direkt i kopplingsdosan vilket kräver en elektriker, i gengäld slipper jag nu byta batterier och att utebelysningen är avslagen permanent när frugan eller sonen gllmmer av sig och släcker lampan på knappen.

Ha una connessione più affidabile e potente

compact size (35x35x15mm) that slips behind switches, ideal for retrofitting. Its tiny size doesn’t sacrifice power, supporting up to 10A loads for lights or fans.SmartThings Integration: As a Zigbee 3.0 device, it pairs directly with SmartThings hubs—no firmware hacks. Open the SmartThings app, scan for devices, and it’s detected instantly. Reliable for automations (schedules, voice commands via Alexa/Google).Installation: Effortless for DIYers. Wire live/load/neutral into clearly labeled terminals (neutral required). Fits standard boxes, even in tight spaces. No need for a bulky hub—connects via Zigbee to SmartThings.Pros:Tiny, invisible install.Direct SmartThings pairing.Affordable Zigbee option.Responsive app controls.beware that requires neutral wire

💡 I set this up specifically to work with Home Assistant, and what drew me to it was its ability to synchronise with the existing light switch position. I chose to wire it into the light fitting since it had a neutral, making the installation straightforward. With just three short pieces of wire, I connected live in, live out, and neutral to the lighting connection block, while the switch terminals went to S1 and S2. The manual included with the switch is quite minimal, relying on the manufacturer's website for additional guidance. My main concern was enabling the switch to follow mode, as the instructions didn't make this clear, but I found some extra details online.💡 Pairing the switch was effortless and completed in seconds. Home Assistant detected it immediately, and once added, the switch mode appeared as an adjustable property, allowing me to configure it as needed. This saved me the trouble of manually forcing the mode during setup. I’ve installed similar smart switches before, so the whole process—wiring, pairing, and integration—took no more than 20 minutes.💡 In use, the switch responds reliably, with no noticeable delay when toggling the light through Home Assistant. The synchronisation with the physical switch works as expected, maintaining the correct state even if operated manually. This is something to be aware of for following mode. If you operate the switch remotely, then the manual switch will be out of sync. You then need to switch the manual switch to ‘on’ before switching in off manually. This operates as expected. Given its compact size, it fits neatly within the existing junction box without forcing the wiring into awkward positions. The only downside is the lack of detail in the included instructions, but for anyone familiar with smart home installations, it’s a minor inconvenience. ✔️