SPEED TIGER ISE Carbide Square End Mill - Micro Grain Carbide End Mill voor gelegeerd staal/gehard staal - 4 fluit - ISE1/8'4T - Made in Taiwan (5 stuks, 1/8')

Muy eficaz

worked good for I what I needed

Good value

Bought these for a hobby. Received them and like that they are packaged individually, thus helping keep them sharp. Used them on a firearm building project and only eneded up using one. But stayed sharp and met the needs of what I was using it for. If your are a hobbyist and looking for some high quality milling bits with out having to pay a premium these are the ones to go to.

I had been using a different brand which just wasn't cutting very well so I tried these. I was able to increase my feed rate by about 30% and the depth of cut by over 100% and they cut like butter! The only problem came towards the end of the cut as it met the spoil board. I snapped off three different bits trying to make the final pass. I ended up switching back to the bit that didn't cut very well, and used it to make my final pass without much of an issue, other than having to slow the feed rate down significantly again.These were the 1/8 inch flat and mills. I have some quarter inch speed tiger bits that I will be using next week.. and I'm hoping for a little better strength.