Tandriem GT2-riem 6 mm breed 2 mm pitch voor Creality Ender 3 3 Pro Ender 3 V2 Ender3 K1 CR-10 Anycubic Kobra 2 Kobra Max CNC en andere 3D-printers (10M)

Heel goed product.exact wat ik nodig had voor mijn sculpfun s9

Alles perfekt. Schon wieder in Betrieb. Schnell und Preiswert. Top!

I got this as a spare belt, and I've not had to use it yet.However I can confirm the dimensions are correct, the teeth spacing lines up, and going by feel I can't tell any difference in stretchiness, hardness, or flexibility between this and a genuine Gates belt.The only real difference I could see, is in the reinforcement strands that run along the belt. This belt has fewer but much larger strands than the gates belts, whereas the Gates belts have far more numerous but much much smaller strands. In practise however I can't see there being much of a noticeable difference in the belts lifespan or performance due to this however though.

Super Riemen für Anycubic Kobra 3

I've not installed this into a system yet, however from the look and feel this is a belt that's comparable to others I've used. The width is accurate (I measured 5.98mm), and I tested it against spare GT2 pulleys and it meshed fine.

Macht was es soll, reicht für 2 mal bei meinem Anycubic. Leider kommt es ohne den kupfer klemmen. Wenn man sich an die Anleitung hält ist auch die Montage Kinderleicht.