Thermalright FAN HUB-besturing REV. A Fan Hub ondersteuning 10 groepen PWM-fans, meerdere interface ventilatorhubs koeling, 10-poort 4-pins PC koeler fan controller, SATA Power Cord Direct-ingang

The fan hub works as intended after receiving and installing.When I first built my pc I had to run the fans in a chained configuration but using this fan hub is a much better alternative and allows the fans to run at their full capacity when needed.Positives:- 9 case fan connections + 1 CPU fan connection- Low profile; you can easily fit the hub into an unseen spot in your case to maintain your cable management.- comes with a PWM cable so you can install the hub right away (the cable has a 4 pin connector but only 3 cables, don’t worry; you can still adjust the speed)Cons:- Okay, this is an odd one but it was the first thing I noticed so I HAVE TO mention it; The hub smells AWFUL, it came out of the packaging smelling like cheap plastic. This at first worried me because I thought something had melted before I even installed it, after checking thoroughly this wasn’t the case. I suspect the parts have just been assembled in a hurry and -put inside a ziplock bag that contained the smell of freshly produced plastic (it’s very present).- While the double sided foam tape is nice to stick the hub underneath your pc’s side panel, it’s just that; tape. It’s an easy and cheap solution and it works fine, I just worry about how long that tape is going to stick to a case with fluctuating temperatures and constant airflow.Overall:A nice hub that functions as it should and isn’t too bad too look at… just don’t hold it too close, or the smell will reveal it’s a budget component in a plastic case.

The hub itself is really good for the price, but it can't be PWM if it comes with a 3 pin cable! Then, all the fans are running at full speed and you have to buy a new 4 pin cable...Can work? (I don't know yet) but it looks like it can. But without the cable, it's useless...UPDATE: I've opened the Hub, and I saw that the circuit is incomplete, there's NO ELECTRICAL CONNECTION from the PWM Input, and when you connect the SATA all goes 100%, so basically, the + and the - from the main input, aren't connected anywhere.... there are no connections AT ALL inside. I don't know how it's designed but, not even the cable it comes with the hub makes sense with this electronic design...

Fonctionne parfaitement.Pour ceux qui considèrent qu'il est "inadmissible" d'avoir une broche 3 pins au lieu de 4 avec le hub, sachez que l'alimentation 12v ou 5.5v est assurée via la prise SATA.Le port "PWM" sert uniquement à la gestion du signal/PWM, et non à l'alimentation.(GND/vide/Signal/PWM)GND = Neutrevide = alimentation 12/5.5v non utilisé car alimenté via SATASignal = Lecture de la vitesse de rotation (affichage des RPM)PWM = Gestion de la vitesse de rotationC'est donc tout à fait normal et parfaitement fonctionnel.Inutile de dépenser de l'argent pour un câble 4 pins supplémentaire.

Usato per collegare 8 ventole corsair, di facile installazione, viene fornita anche una gomma biadesiva per attaccarlo al case.

Gut

Puede cumplir su cometido y tiene un precio muy bueno, pero es absurdo que acepte PWM y traiga un cable de 3 pines que lo anula por completo, sobre todo si anuncia que viene con uno de 4. Es necesario comprar un cable PWM macho a macho para que funcione como es debido (o todos los ventiladores conectados funcionarán a máxima velocidad constantemente).