The Assembly was a real challenging but the case had some drawbacks It was not built for intel workstation motherboards with dual processors. I found it a little difficult to install the heat sinks for the two processors as there was no provision for standoff's. The Intel workstation motherboard " S5000 XVN SATAR " is of dimensions " 12 inch * 13 inch ". I was able to fix it on one side only. There was a delay of 22 days for lack of back plate for LGA 771 socket with which the heat sink’s could be fitted. The " S - E " screws were useless as they troubled a lot. They couldn't be tightened properly. " S - F " screws had to be replaced with local long ones as the length of these screws were insufficient to fix 140 mm fans. I faced a little difficulty in fixing 3 fans below the on off reset switch at the front as the screw holes provided for fan fixing were not matching ( of course by adjusting the slotted plates provided). I had to enlarge the holes provided for the slotted plate to accommodate the 3rd fan as the gap was less. Two openings are provided for fixing the SMPS module. If only one is used, the other has to be closed. There is no cover plate provided to close the other opening. I had to cut the plate that had 2 slots cut in the middle and fitted with 2 rubber bush like seals that are in the same profile as the slots cut. I had to mark the opening dimensions in the plate, cut the plate linearly and drill holes at the four corners for screwing. Since the motherboard is not a new one, the seller did not provide me with a plate that covers the USB, E5hernet, mouse and keyboard ports. I purchased GI sheet locally, cut the edges and made it in to a rectangular cup like shape to suite the rectangular opening provided at the rear end and closed it. My next problem was securing the cables with tags. Though some projections and slits were provided for tagging, the cable routing from the SMPS to the respective components was a real challenge. I had to use the perforations in the casing to route the cables to avoid congestion. One of the “ S-G “ screws sheared-off due to over-tightening of the “ S-H “ nut. I had to buy few of the local screws with nuts to finish the installation of casters provided. Most important…. I did not receive “ O-A “, bezel bolt holder with the fasteners. After that during the final stages the installation began to ease and things got a little better but my assembly work much to my surprise was awfully tough and challenging. (Photo take during installation).

Keine Betriebsanleitung, wie soll man das Ding ohne zusammenbauen, Support hat mir zwar en Link in einer PDF geschickt, warum in einer pdf? Denn man nich öffnen kann, und auf der Homepages ist nur ein anderes Gehäuse unter dem Namen zu finden, das kotzt doch schon wieder mega an.

this is only 1/2 of what i want, i also want the w200, but its nice.It fits a lot of fans, i just need a better power supply and the top part and i can use my old pc and new one, thats the plan at least

P200 Pedestal Case does not come as pictured. It doesn't include the top pictured. If you're going to not include it, why picture it. And if you're going to try to show the bottom can be used as a bottom or top, then don't include both in the same picture. (if you're saying that the bottom isn't clear in the picture, it sure is as the legs are attached to what?) Also, the top pictured has corners showing it's not flat like the bottom so the lid pictured is not the same as the bottom piece included.

WORKS GOOD!