TOOLCOOL 340 mm spoorzaag vierkante cirkelzaag geleiderail vierkant compatibel met DeWALT geleiderail (rood)

Without a right angle jig a track saw is half as useful, this works for DeWalt track and DeWalt track saw very easily and very well

Using it with a Powertec guide rail, which works fine if you remove one washer from each of the locks. Got it square with a 1-2-3 block and it makes perfect 90 degree cuts.

Well, I was doubting this to be any good.I was wrong.It's a near perfect (one or two thousandths of an inch) right angle based off of a 18" precision right angle guage. (See pics). If your cutting larger stock, ie: 4x8 sheets, you should be measuring to confirm as nothing this small is that accurate.Slide unit onto Dewalt track saw, then tighten two thumb screws. By its design it auto centers and creates right angles. It even comes with a flip out material brace to keep the unit from falling down while measuring or cutting.Its about as good as you're gonna get elsewhere but at a fraction of the price.

I tried using my 4ft track and it wasn't square. It did connect to my track easily though.

Toolcool's track saw square is a reliable tool for ensuring precise cuts when used with compatible DeWalt guide rails. It is simple to attach and adjust, significantly improving cutting accuracy for various projects. The solid build inspires confidence in its longevity, although it is a bit on the heavier side, which might affect maneuverability for some.