ULTRA-G GI100

I have 4 of these. Always reliable and quiet. Just like they should be.

What do you do if you have a tube guitar amp that sounds great and you want to get that sound onto your home studio recordings? The pros use expensive microphones and a sound-proofed room in a studio, but you're probably working in a small room with no sound treatment, noisy air-conditioning, traffic sounds outside, and so on.The answer is this magic little red box. I run the speaker out from my Super Champ XD guitar amp into the Behringer DI box, then plug the guitar speaker into the DI box to provide a load for the amp. The other end of the GI-100 puts out a clean, noise-free signal into a microphone (XLR) cable that runs to my recording equipment. No expensive microphone, no worries about ambient noise or a bad-sounding room, and lovely tube-amp tone on the track (or in the P.A.).The speaker cabinet emulation in the GI-100 is a bonus, try recording both with and without it and see which you like better.There are other uses for this little box, of course. For those who don't know, electric guitars and basses need what is called a high impedance or high Z input, while most mixers and P.A.'s and recording hardware have low impedance input jacks. Plug an electric guitar or electric bass straight into a mixer for recording and you'll get a very dull, unattractive tone. Put this Behringer DI box in between, and you'll get the clean tone from your guitar on the track, ready for later re-amping or processing through your software guitar amp model.Instead of a mixer or multi-track recorder, you can also use the GI-100 to feed a P.A. system for gigs. Once again you avoid the hassles of micing your amp, and you'll get a cleaner signal into the P.A., free from ambient noise that a mic would pick up.Finally, this GI-100 can convert an unbalanced signal (such as from your electronic keyboard) to a balanced signal to feed your P.A. system. This can reduce hum and electrical interference issues.Likes: The Behringer Ultra G GI-100 does what it's supposed to do, and does it well. And it's so inexpensive that it's an absolute bargain.Dislikes: No on-off switch, so you have to pull the cables after each use (or remove the battery and power it with phantom power from the mixer). The GI-100 has no signal strength meters of any kind, so you have to guess at the signal level coming out of it. Rather than two -20 dB pads, I would have preferred one -20 dB pad and one -10 dB pad for more versatility.Summary: The Behringer Ultra G GI-100 is a very useful little tool that solves several problems in the home studio and for live performance, and does so very inexpensively.-Gnobuddy

dogru orinal ürün uygun fiyat tşk amazon..

Elimina por completo el ruido estático en el amplificador!

Essencial para tocar em linha