UPANBIKE Handgemaakte ergonomische handgrepen van leer

Alles bestens.

Lovely finish

Der Griff für die Schalter Seite k{nnte etwas länger sein. Sehen super aus. Lassen sich gut beim Radfahren anfassen.

I ordered these based on another users review, as I was looking for a pair of bike grips to replace the worn, ripped ones on a Victoria Pendleton Somerby bike I just bought secondhand.These are a good replica for the Somerby bike if you are looking for a replacement. My two comments would be that the shade of brown is slightly lighter and the width of the handles are slimmer than the originals (the length is the same so fit onto the handlebars perfectly).I didn't have to cut the original handles off to remove them, just did the following:1. Loosen the screws for the brake levers and move the lever casings towards the middle of the handlebars.2. Using a flat headed screwdriver, prize it underneath the bike grip to create an opening.3. Spray a lubricant (I used WD40) into the opening).4. Repeat this method as many times as needed on both ends of the grip to loosen the grip.5. Twist the grip and pull at the same time to remove the grip.I found the grips a bit stiff to put on, but a bit of WD40 inside helped. If you use too much (I did), just wipe the excess out and repeat until the handle goes on smoothly and stays put.

I have a Halfords Victoria Pendleton somerby Dutch bike (the popular summer bike) and my my grips starter to tear, these are literally a replica of the original grips! Halfords don’t sell replacement grips for the Pendleton bikes so if anyone has one and needs to change the grips I suggested these they fit perfect exactly the same style and fit. Easy to fit with some Vaseline on the metal bar to slide into place. The original Pendleton grips I had to slice of with a stanly knife to get to the mental bar.