Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Victron Energy BatteryProtect 12/24-Volt 100 amp

33,99€ 70,16€
Gratis verzending bij bestellingen boven 25,99€

Over dit item

  • Victron Energy BatteryProtect verbreekt de verbinding van de batterij met niet-essentiële belastingen voordat deze volledig wordt ontladen (wat de batterij zou beschadigen) of voordat er onvoldoende vermogen over is om de motor te starten
  • Maximale continue belastingsstroom 100 ampère en piekstroom (gedurende 30 seconden) 600 ampère
  • 12/24-Volt auto ranging - De Battery Protect detecteert automatisch de systeemspanning
  • De Battery Protect kan worden ingesteld om in/uit te schakelen bij verschillende spanningen, het zeven segment display geeft aan welke instelling is gekozen
  • Onjuiste installatie kan gevaarlijk zijn, raadpleeg een erkende professional en volg alle van toepassing zijnde elektrische codes tijdens de installatie



Productbeschrijving

Victron Energy BatteryProtect 12/24-Volt 100 amp header
Victron Energy BatteryProtect 12/24-Volt 100 amp dimensions
Victron Energy BatteryProtect 12/24-Volt 100 amp features
Victron Energy BatteryProtect 12/24-Volt 100 amp… what in the box
Victron Energy BatteryProtect 12/24 V, 65 A connections

andre G
21 juli 2025
J’ai installé cette protection sur les 4 batteries de service de mon voilier en faisant bien attention qu’il n’y ait pas de courant inverse. Le module défectueux n’a pas été couvert par la garantie. Le technicien de Batterie Megastore ayant une mauvaise lecture de mon schéma électrique…
ARTUR
29 juni 2025
Good product and quality
Neil F.
14 juni 2025
Really simple to install, and rock solid connections.BE AWARE: When set for Litium Battery this device MUST be used with something like their BMS to disconnect the load.That point wasn't very clear to me in the instruction manual (a case of "reading into" on my part). When I researched the issue on their web site is was explained much more clearly there.I was able to run my LFP battery down to 11V when it was set to cut off at 12V. I was testing it manually and on purpose, so no damage was done. The battery charges just fine even with the load disconnect ciruit open.Was able to burst a 141Amp load through the device without issue (as measured by a BMV 700).This will be my Go-To product for any project requiring battery protection from here on out.Pros:Rock solid build that can physically hold up to the type of cables and connectors that will be used.Set and forget programming.Automatically allows battery to charge when load disconnect circuit is open.LVD can be controlled by other devices, and switch.Cons:Manual Rev08 27-03-2017 doesn't clearly let you know the load will NOT disconnect by itself in Lithium mode. Buzzer and Relay mode state clearly the load WILL be disconnected.
CheliLPR
17 maart 2025
No funciona, da error de cortocircuito sin nada enchufado, solo al ponerlo.
SW
3 november 2024
Awesome device: app works great. Bluetooth short distance.