VIFERR Draaitafel Lager 6 inch Aluminium Tafellager Ronde Heavy Duty Draaitafel voor Tafelblad Serveren Eettafel TV Monitor Stands

Sarebbe gradita una superficie antiscivolo lungo tutte e due le parti, non solo quattro gommini. L'ho modificato in tal senso.

This is a good product for your dining table. Built quality is good but not impressive. This is made of aluminium so not too heavy. It spins smoothly but not freely. I would say good for cake making because you don’t need to move freely.

endlich kann der kleine Fernseher je nach Sitzposition gedreht werden :-)

Ich habe das Tischlager gekauft um einen grossen Teller drauf zu stellen und zu drehen. Es sollte bei einem produktvideo benutzt werden. Leider ist das Kugellager so schlecht dass sich der Teller nur kurz und unglaublich ungleichmäßig gedreht hat. Ich konnte das Video letztendlich damit drehen musste aber in der Nachbearbeitung einiges in Ordnung bringen. Zudem habe ich versucht das Kugellager zu ölen, aber das hat leider auch nicht viel bewirkt. Also für produktvideos nicht wirklich gut geeignet aufgrund der schlechten Kugellagers. Für Drehteller am Esstisch bestimmt ganz ok.

This was supplied in a thin plastic bag. No protection whatsoever, aside from whatever packaging Amazon adds on top; usually a thin carboard box.As such, it arrived with a few dents and scratches that may have been present from the factory, or appeared during transit. Either way, it could really do with being wrapped in something to protect it.Does this affect usage? No; thanks to be milled out of solid aluminum, it's going to take a lot to break this.The machining is actually decent. It has a consistent finish and the two parts fit together well. The various mounting holes (~4.9mm) are pre-fitted with hard rubber studs. These allow you to use the bearing without permanently mounting it to whatever you're using this for; relying on the mass of the load to keep everything in place.However these holes are also countersunk; allowing for mounting with countersunk head screws or bolts, which is how I'd suggest you mount this.The bearing is not free spinning. It moves smoothly when pushed, but stops immediately rather than slowly spinning down to a stop. I consider this to be a good thing for most applications I'd use this for.The dimensions given in the product description are inexplicably very crude: "There may have 0.5-1cm error in size".For reference, the actual inner diameter is ~88.9mm and the outer diameter is ~140mm. Center to center hole spacings are about 101mm and 128mm for the inner and out rings respectively. The thickness of the plates is ~8.5mm (about 16.7mm including the preinstalled top and bottom feet).An M6 grub screw closes the hole through which the bearings were inserted on the outer ring, so you can remove/replace these if you have reason to. I suspect the aluminum rings will fail before the steel bearings do.There is a little bit of vertical play in the bearing but this isn't noticeable once a load has been applied to it.For less than £10 I consider this to be a good value. It will absolutely do the job it's intended for and the minor cosmetic issues resulting from poor packaging (or perhaps rough handling at the factory) are not going to be visible or impact operation once installed.