Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Wandhouder voor lange halter, voor thuis, commercieel gebruik, garage-sportschool

6,99€ 14,22€
Gratis verzending bij bestellingen boven 25,99€

1.Kleur:Dubbele Stanghouder


Productdetails

  • Afmetingen: 12,5 cm x 10 cm x 9 cm. De dikte is 5 mm, zwart poeder afgewerkt biedt roestbescherming en een prachtig uiterlijk.
  • Een aan de muur gemonteerde halterhouder kan effectief meer ruimte besparen en je fitnessapparatuur netjes opbergen. Het verhoogde uiteinde kan voorkomen dat de halterstang of andere fitnessapparaten vallen.
  • De opening tussen de tanden is 32 mm. Compatibel met standaard of Olympische staven met een diameter van 25-28 mm of vele andere staven met een diameter binnen 32 mm.
  • Multifunctioneel voor het ophangen van Olympische halters, krulstangen, kettingen, weerstandsbanden, springtouwen en andere trainingsapparatuur.
  • Internationale producten hebben aparte voorwaarden, worden verkocht vanuit het buitenland en kunnen verschillen van lokale producten, zoals pasvorm, leeftijdsclassificatie en taal van het product, etikettering of instructies.


Productbeschrijving


MHkaserz
6 augustus 2025
It can BARELY hold 30mm bars and they don't provide cage compatible screws, hence the point deduction.
Trent Pennington
21 juni 2025
Does the job and is solid
90daywarranty
1 april 2025
While getting my garage gym put together I noticed that I had accumulated multiple barbells, and didn't have a good way to store them. They were either on the ground or leaning against a wall/corner.After spending some time looking at different offerings here on Amazon, I finally found these, which at the time were under $10 each. Whether or not that represents a good value to you probably depends on how many bars you have to deal with. I have four total but the hex/trap bar is not a good candidate because of the collar design. So only needing three was ok. If I had five or more bars, I would probably consider one of the floor stands, depending on space constraints.The hangers arrived in a simple cardboard box (but double boxed not mailed individually). Inside the box was the hanger itself in a plastic sleeve, a piece of precut rubber mat/padding with 3M adhesive backing, and some questionable looking drywall type anchors w/ screws. I wiped the hangers down with alcohol before applying the pads. The metal of the hangers is very substantial @ 5.34mm which is somewhere between 3.5-4 gauge thickness. Once properly secured I don't think you ever need to worry about bending them. I ended up screwing them into a board that was itself anchored to multiple studs.The only thing I would point to as a potential drawback is the finish quality. I'm talking mainly about the paint. I had a couple of small chips right out of the box (hard to see in photos but circled in yellow). Given their purpose I wasn't too concerned, but if you like everything to be perfect you may need to hit these with a rattle can or otherwise refinish them.Overall I'm happy with their performance and function. If they were much more expensive I would be inclined to be more picky, but these are fine. Just remember to replace the screws and make sure they are well anchored, not in drywall. -Cheers
Geoff
26 februari 2025
The rubber came off but otherwise it’s great
ÁNGEL ORTA LOZANO
6 november 2024
ExcelenteCuenta con los aditamentos para colocarlo incluido el nivel útil de gota para su mejor instalación.