Waveshare 4.3 Inch Touchscreen DSI LCD met Case voor Raspberry Pi 4B, 800 × 480 Resolutie IPS Monitor Capacitieve Scherm Ondersteuning Raspbian/Ubuntu/Kali/Retropie/WIN10 IoT

Geweldige display .Deze word gebruikt om de Victron venus os te draaien op een Raspberry pi4b.Werkt gelijk zonder probleem.Let op als je dit gaat gebruiken er voor.Venus os geeft alleen bij op start de logo Victron.Je moet inloggen en de unit activeren aangezien de venus os van uit gaat geen Display aanwezig is. (Je heb beeld met de Victron logo)

This is a carefully crafted unit, easy to install for those familiar with electronic interface sockets. No documentation for setting up was provided, but then again it's not needed. No driver is needed for it for Raspbian on RPi4, and certainly no driver is available for Kodi and libreelec and hence the screen is upside down if fixed in suitable enclosure compared to the intended position of the enclosure . Touch functionality works, but a little slow at times, but not a real issue. Screen is clear and bright when viewed from above.

Ekran na raspbianie dziala od razu po podlaczeniu, nic nie trzeba ustawiac. Wentylator na zdjeciu jest podpiety do zlych pinow, prawidlowo w dolnej linii 2 i 3. Koniecznie trzeba dodac radiator do procesora, inaczej wentylatorek nic nie pomoze. Obudowa moglaby byc aluminiowa, wtedy warto by bylo nawet doplacic, ogolnie spasowanie 7/10.

Funciona bem foi só ligar ao raspberry fadei logo imagem 5*

This case/screen combo is amazing! Very high quality, easy to assemble and the final product looks so great! I'm using for a Kali Linux distro and while other touchscreens I've tried would not work as touchscreens with Kali, this worked on first boot! No drivers to install, just a few lines in the config file.Two downsides: light bleed from the bottom of the case, not a big deal at all, just noticed this morning in a dark room, otherwise, not noticeable. The possible bigger downside is there is no way to swap SD cards without completely removing the back of the case and maybe the display ribbon cable since the TFT port is between the screen and the pi and the display cable goes right over that (you can see in the picture with the case open, the TFT slot is behind the gold display cable). I'm going to try a TFT extension to see if I can make swapping cards easier, but even if I can't, this is a great case/touchscreen combo!EDIT: Tried the TFT extension, but there just isn't enough room without blocking the display cable port--however, the pi 4B supports booting from USB and I'm using that method now instead--working terrific! I plugged in a standard USB SD card reader and it would boot from that image. Every distro I've tried has worked with the touchscreen with no additional setup and when I connect an HDMI display, the HDMI takes over and the small panel turns off just like you'd want it to. Can't say enough good things about this setup!

Funktioniert super. Auch für Nicht-ITler einfach in Betrieb zu nehmen.