Gute Ware, Danke, der DSI-Anschluss ist perfekt!

Bonne qualité, néanmoins avec une raspberry PI 4B, la carte sd n'est plus accessible une fois la boîte fermée. Il faut à chaque fois dévisser la boîte pour l'ouvrir et passer les doigts sous un ruban de connexion pour attraper la carte sd donc pas pratique du tout.Le ventilateur ne marche pas.Autrement, l'écran est plutôt fiable côté tactile. (Mais je pense que se serait mieux d'avoir un stylet avec car c'est pas simple car l'écran est vraiment très petit pour des doigts d'adultes..

Just thought I'm gonna post few things here as a review, answers to questions I've been asking myself before I bought it.The quality of the case is very nice, it isn't cheap plastic and even though it does say its 3D printed and you may feel the surfaces is a little bit rough, its not the case at all, at least with the one I bought.Now, the screen quality is very good, the picture is crisp and nice, even for such a small screen. Really happy with that.The 5V fan is quiet, I used to have a bigger fan in another case, connected to 3.3V GPIO pin (lower power, less noise) and this one is as much quiet as that one I had.The fan is mounted in the back of the case and I have the case hanging on the wall with the fan side facing the wall with the 5mm gap in between, still Pi (DietPi) operates at optimal temperature of ~44°C which is nice. I've stress tested it (CPU+Memory+Storage) and it maxed to 57°C which is still very spot on and very acceptable so the fan does the job very well.Screen itself is at normal room temperature, it doesn't heat up or anything similar.The case , screen and fan are very easy to assemble, really no instructions needed, just look at the photo here then check the GPIO diagram to connect the fan and thats you sorted.Good buy. Worth the price, looks nice and does the job.

The device was very easy to assemble and use, however having a printed manual would be beneficial.

Il kit arriva ben imballato e si monta pochi minuti senza bisogno di istruzioni.Sono presenti due flex per il collegamento alla porta del display del Raspberry.Il monitor è luuminoso e con ottimo contrasto.Con pochi cm in più rispetto a quello da 3.5" si riesce a utilizzare lo schermo in modo più comodo.Se non è vincolante il dover rimanere entro la sagoma del Raspberry lo consiglio al posto di quello da 3.5".Una volta collegato il flex alla porta sul Raspberry diventa un pò difficoltoso inserire o estrarre la micro SD con il sistema operativo.Forse potrebbe costare leggermente meno, ma per il momento ne sono più che soddisfatto.