Werkbankframe onderstel voor werktafel 50x125x80 cm (bxlxh) werkbank inpaktafel frame

Ottimo prodotto... Incredibile assortimento di misure che si adatta a qualsiasi esigenza. L'ho completato con una tavola in multistrato da 2,5cm tagliata su misura (25€) ed é diventato un tavolo perfetto per il mio utilizzo.Prodotto massiccio, ben fatto e ben rifinito

Getting a table this size for cheap comes with a few drawbacks, no question. As some reviewers pointed out it can only be mounted in one way, so i warmly recommend reading the instructions and sorting out the parts before screwing it together.The steel tubing is thin, and tightning the bolts can deform the hollow steel tubing if you overdo it. I solved this by 3d printing 4 solid blocks (37.5x37.5x40mm) and inserted where the bolts insects. This allowed me to tighten the bolts without mashing the tube. You could do the same with wooden/aluminium blocks too.Quality of the 90 degree cuts leave a lot to be begged for, but for this kind of money you can not expect it to be top-of-the-class, however with these modifications it actually not a bad table-frame. Well worth the little effort it took to make it it more stable as i will place heavy machines and parts on this table.

J'avais déjà un beau panneau en bois, il ne me manquait que les pieds, simple à monter. Seul c'est possible mais à 2 c'est toujours mieux.

Assemblato con facilità, resistente e ben fatto! Forse il prezzo è un pò alto ma ne vale la pena, lo consiglio!

Il faut lire et comprendre le plan très attentivement.Toutes les barres ne sont pas identiques et c'est normal.En revanche il faut effectivement ne pas trop forcer dans le serrage des boulons car les montants en acier peuvent se déformer.Par ailleurs, les vis ne semblent pas être de qualité car l'emprunte de vis se déforme aussi si vous vissez à la visseuse éléctrique.