Werkzeyt Japanse trekzaag, 265 mm / B25320

Je denkt eerst is dit het nou.Maar zaagt moeiteloos door Azobe hardhouten palen van 6 cm.Stond eerst met een normale zaag te hannesen, maar dat schoot niet op.Deze vloog er door heen.

Zeer scherp en handig in gebruik voor fijn werk.

Diese Säge ist super! PunktNatürlich gibt es für mehr Geld besseres aber das Ding ist wirklich top.Habe unser Carport damit gebaut und den Dachboden. Gerade Schnitte gelingen ohne Mühe.Da greift man eher zu dieser Säge als zum Elektrowerkzeug.Scharf ist sie immer noch. Nicht wie am ersten Tag aber völlig ausreichend. Mein Toptool für Holz! Nicht für Laminat der Kunststoffe.Für den Preis bitte ausprobieren und selbst überzeugen lassen.

Un ottimo attrezzo professionale ad un costo contenuto...

Je n'avais pas eu l'occasion de tester de scie japonaise avant mon achat...Quel bonheur! Coupe super bien et précisément.Attention aux doigts tout de même!

Buenas sierra, que aunque corta hacia adelante (no al tirar hacia el cuerpo) tiene un corte muy preciso y rápido. Mejor que las sierras convencionales

Recently, I needed to buy a new flush cutting saw for work. I've used Japanese pattern pull saws for nearly twenty years, and I have owned several ranging from cheap European saws, to very expensive Japanese ones.I work as a cabinetmaker, and use hand tools every day.This is a German made pull saw with a Japanese cross-cut tooth pattern.I had a large amount of kitchen doors to make recently. These had to be lipped in 10mm thick solid oak. This would be moulded later with a router.Each piece of oak was glued on, over length, and had to be trimmed exactly flat and square afterwards. This meant eight cuts per door (two on each side).I had about twenty doors and drawer fronts to make, so approximately 160 accurate cuts had to be made. In addition, each strip of oak was first cut to a rough length from longer stock. I think that this was a proper test of this saw.This saw performed brilliantly. The cuts were smooth and flush. There was only a minimal amount of flushing off with a block plane afterwards, on a few of the doors.I saved a considerable amount of time using this saw. A couple of weeks on, and there are no signs of dulling to the cut.I would highly recommended this saw, especially because of the excellent value that it represents.I expect this saw to give me many years of use. It cuts very quickly, and extremely cleanly.