ZkeeShop 5 stuks uitbreidingssensor, schild modules, compatibel met Arduino UNO R3 Nano I/O

Maybe the board fits to arduino Nano, but it definite does not fit on an Arduino UNO board. The pin holes on the Analoge side are too close together so it will not fit. if you press it in with force, both boards will bend and break. Not for Arduino UNO

Funktionieren bestens.

This item is a good deal and was shipped very quickly. These are a must if you plan to do some rapid pro-typing. Its significantly better than plugging the nano directly into the bread board. It prevents the nano pins from being damaged. Also it has the ability to be powered by a wall wart/ 9V battery. Once you are done you simply move your design to a board and start your next project. Also, since each pin breaks out a separate 5V and Ground hook up is very quick. These are so cheap that if required you can leave the nano plugged in and use a slightly larger box for you project and reach for another board for the next project. Why did I dock one star? couple of the boards I received had some flux residue and one barrel power connector was a slightly angled. But you can't beat the deal even if you try to buy from "cheaper" sources online when you factor in the shipping speed.

Fait son job 👍🏻

Es una placa con fines de simplificar montajes y cableados. Ayuda mucho, por incluir la toma alimentación y todas las patillas del propio Arduino.Me alegro de la compra de los cuatro conjuntos. Lo recomiendo compra OK

Ottimo prodotto