Airflow 72687103 HTM iCON plug-in vochtigheids- en timermodule voor 230V-ventilator

I bought one of these alongside the actual iCON fan to replace an existing, failed Aitflow unit. As a drop-in replacement it works great. I also took this opportunity to switch to a humidity module. I can’t think of any cons other than that quieter units from other brands are available.The instructions weren’t exactly clear how you configure the module to run so I’ll add some notes here from my own googling. A key aspect not made explicitly clear in the instructions is that you do not have to connect the T (Live Trigger) terminal which comes from the light switch.It is very likely that existing and new installations will use 3 core cable which have colours: brown, grey and black. A good practice is to use those wires as follows putting a bit of electrician tape on it for future reference to state purpose:Module connections:L - Permanent Live - core brownN - Neutral - core grey (tape it blue)T - Live trigger - core black (tape it brown)If you don’t want to use a timer or humidity function, and just use the light switch, you can have core black going to L.If you don’t want to use the timer (which needs T) - don’t connect T. If you don’t want to use the pull cord I found it can be rolled-up and taped inside the unit. Note that the pull cord is electronic, not a mechanical switch, and is only used to turn the fan ON. Repeated pulling of it resets the timer to start again. If you turn the timer to its minimum setting, that was about 2 minutes in my test. I had no need for the pull cord as I have an isolation switch outside my bathroom which is easier to access. In the rare situation when you want to disable the fan - perhaps you are having a bath listening to music - that isolation switch can be used.I am using the module as humidity detection only and I have not changed the factory set dial. It comes-on three minutes into a shower.If you connect T you get the fan on with the lights every time but the humidity detector will keep it on until steam level drops. I don’t see the point of that mode myself.If you are pondering which module function to use - I would say that when using the toilet at night without turning on the fan, and potentially disturbing others, this is a really good feature of the humidity detector.

parfait rien a redire

Facile à monter, on peut régler le taux relatif à l'humidité(40- 90%) et le temps très bien, à suivre dans le temps.

Après 1 mois d'utilisation, il ne s'arrête plus et fonctionne en continu.C'est le second que j'achète et les 2 ont eu ce même défaut.Préférez un vrai interrupteur.

Ich habe meinen ersten Lüfter 2012 einbauen lassen und musst nun einen der beiden verbauten austauschen. Der andere läuft noch klaglos!. Der Lüfter ist ganz in Ordnung, leider etwas laut, aber für Dusche und Bad gerade noch akzeptabel. Der Austausch ist einfach, genauso wie die Installation. Laufzeit 11 Jahre ist gerade noch OK. Man kann das alte Steuergerät auch im neuen Lüfter verwenden. Damit ist der Preis akzeptabel.