Koop dit i.p.v. van AliExpress en chinees troep. De kwaliteit is vele malen beter.

Ahora sí engancha bien

Works as they should

This is a nice little set of various pieces and spare parts that is handy to keep around when you’re trying to build that perfect GoPro mount. The set includes a curved mounting base with 3M VHB tape, a flat mounting base with 3M VHB tape, a standard height mount, an extended height mount, a pivot arm that consists of two pieces, two small thumbscrews, a standard length thumbscrew, and a shorter thumbscrew.If you combine the curved mounting base, the standard height mount, and the normal thumbscrew you have a duplicate of what usually comes with a GoPro camera. Then you’re left with the flat mounting base, the higher mount, and the pivot arm. Combining those parts gives you a nice raised arm that can pivot both back and forth and side to side so you can get a level shot even if you need to mount the base at an angle.The set includes a shorter thumbscrew that can be used when you don’t want the thumbscrew to extend beyond the edge of the camera. This is useful if you are tilting the camera at a 90 degree side angle as it allows a full tilt without the thumbscrew impacting the main part of the mount. The only downside is that the tolerance is very tight and it will be hard to fully tighten the thumbscrew so you may need to use a screwdriver to tighten it down if you need it to be completely locked in place.I mainly got this set in order to get the extended height mount and the pivoting arm. Combining these two things will raise your GoPro about 3 inches off the mounting surface and provide a different perspective versus the standard low mount. I’m using a GoPro mount in my car and the standard mount results in video that doesn’t give a good view of what’s directly in front of the car. Using this kit allows me to raise the camera up higher and angle it down a bit to get more of the ground in front of the car in the frame.All of the pieces seem very sturdy. I’d much rather pay a little more for the genuine GoPro accessories versus having a cheap knockoff fail at a bad time. Highly recommended set if you’d like to add some versatility to your setup!

A perfect grab option to enhance the gopro extensions2 long screw 2 small.screw..3 joint extensions to support while.on helmet or on suction cup2 additional adhesives for users comfort and backup if one cracks you have the option to replaceBest in price ....durable

Did not include parts for the gopro 3-Way. The picture indicate the parts looks like thumb screw for the gopro 3-way but they are not the same. Wasted.