JSER Xiwai PCI-E 4-Port SATA 3.0 uitbreidingskaart eSATA PCI-E SATA3 6Gbps PCI-E Adapter

Op de PCIE-1 interface eSATA / SATA is niet te zien wat nu welke stand is, maar deze staat standaard op SATA ingesteld, wil je de eSATA hebben dan moeten alle 'stekkertjes' omgezet worden.BOOT TIP:Wil je op de juiste manier kunnen booten dan moet UEFI ingestelt zijn, anders werkt het niet (oude moederborden bij wie dit ontbreekt, pech, je zult een andere moeten uitkiezen.Dit kaartje wordt dan als 1e aangesproken, dus wil je kunnen booten dan op dit kaartje de Bootschijf zetten, anders wordt de boot sequentie immers ook weer trager qua doorschakeling.Had de eSATA extern (600 MByte) alleen nodig ivm back-up doeleinden,dat is veeeeel sneller dan USB3.1 (40 Mbit) immers.

I am using this in my old Dell T110 II Server re-purposed as an Unraid NAS. It seems to work fine. Oddly, it is recognized by Unraid as a ASM1062 chipset. Physically the chip says ASM1061 printed on it, so I'm not sure which is right.As the description says, the card may have 4 ports total, however, only two can be active at a time. This is controlled via jumpers on the board. Out of the box (or rather, out of the static bag) they are configured to use the two internal SATA plugs. Since no manual is included, there is a small chart printed on the board describing how jumpers need to be set for a particular plug to be active. It's a little hard to decipher, so I'll try to explain:You will see two blocks of jumpers on the board:J8 J7 J6 J5 J4 J3 J2 J1Assuming the "top" of the card is the side with the internal SATA connectors: There are 3 pins per J# jumper column, Pin 1 is the lowest Pin, Pin 2 is the middle, Pin 3 is the top. The chart lists which pins to "jump" in order to activate it. So if you want to activate both eSATA ports (CON1 and CON2), then all 8 jumpers need to be set to jump pins 1-2. This will leave the internal SATA ports disabled.Myself, I have one internal SATA (CON3) and one eSATA (CON2) connector enabled which is:J8 J7 J6 J5, pins 1-2 jumpedJ4 J3 J2 J1, pins 2-3 jumpedTo enable only the 2 internal SATA ports (the factory setting), all 8 jumpers should be set as:J8 J7 J6 J5, pins 2-3 jumpedJ4 J3 J2 J1, pins 2-3 jumpedNote that you cannot have certain combinations of connectors active. Example CON1 and CON3 cannot be active at once since they use the same jumper block.

good good

Idéal pour piloter des disques durs externes avec des liaisons e-sata

説明によると4のうち2だけが使えるとのことだが、ジャンパーピンの説明がない。怖くて使えない。せめて説明書ぐらい入れておいて欲しかった。

Easy installation, worked straight away, runs 2 x SSDs.