MANN-FILTER Brandstoffilter PU 825 X - Brandstoffilterset met afdichting / afdichtingsset - voor personenauto's

Audi a3 tdi 2011 S series. 180kRemoving the torx screws was easy enough, as they are stainless.Used wire ties to hold back lid assembly after prying off with a small screwdriver.Lifted out old filter partially to drain, then removed. Compared size of old and new filter, ok. Changed out old o-ring for new after putting diesel on new o-ring.Upon reassembly, I was surprised there was an 1/8" gap between filter housing and lid assembly. I pressed down hard with fingers but gap remained. That resistance is caused by the o-ring (new or old ring) acting as interference. Replaced the screws and evenly tightened down for the wedding night fit, on the filter housing. I didn't have much fuel remaining in the housing after replacement but the car started right up without any issue.One thing you gotta know with these cars is you'll be doing a lot of your own maintenance if you buy one. I've also bought many tires as this car wears them pretty quickly on the rear, even after alignments. The intake manifold actuator motor fix, P2015, which is a small metal abutment you can purchase on Amazon and install to solve the engine light from coming on, and keeps your air fuel ratio correct. Cheers.

Perfettamente compatibile con Audi A3 sportback 8PA , motore BMN 2.0 TDI 125Kw; o-ring di tenuta incluso.Piccolo consiglio: considerata la manica di "volponi" che si incontrano al giorno d'oggi...e mi riferisco agli onestissimi distributori di carburante che si ritrovano, chissà come mai, le cisterne con più acqua del consentito ( nella mia zona prov. CO nell'arco di 6 Km. e pochi mesi 2 sequestri ) è bene sostituire il filtro carburante un pò più spesso.

Parfait ! Belle qualité, compatibilité parfaite !RAS

Decent filter. Tip, grease the new o-ring once fitted and ease the top down even. Don't get one side down and use the screws to force the top flat which was my first mistake! A slight rotation of a few millimetres when pushing down the top makes all the difference in getting it sealed!

lt. Amazon passt er nicht beim Touran mit BLS Pumpe Düse Motor. Aber wenn man die Originalteilenummer eingibt, kommt der Filter daher. Und siehe da er passt. Alles Dicht. Wechsel Problemlos. Verstehe manche Rezessionen nicht. Vielleicht sollten manche Leute doch in eine Werkstatt fahren.