Orbiter Extruder V1.5 Dual Drive Direct met Moons Motor Compatibel met Ender 3 V2 Pro Ender5 Plus CR10 BLV Voron V2.4 Prusa MK3S Ook geschikt voor DDE-O TPU Printing

I've been using LDO products for quite some time now. this extruder suited the needs of my machine and its really lightweight meaning if you are using linear rails its equals into more speed of your machine. What even surprised me even more i was expecting a 1.5 version of the orbiter as that is what is in my formbot troodon v1 and this was a 2.0 super pleased with the product and the lightweight and improvements done to the extruder itself i am loving this product.

I didn't know v2.0 that is lighter, shorter, better filament path, and better gears was out. Lucked out and my v1.5 came with a LDO-36sth20-1004ahg(xh) motor. The extruder works fine, can be finicky when loading filament but if filament is not too bent will load fine. Have not tried flexibles yet. When set to 850 rms it get really hot, it runs much cooler at 700rms. I have not noticed any skipped step but I've only taken my machine to 130mm/s. I only got this because the Voron guys were high on these but after watching the youtube reviews I guess you should check to see if there is any lube in it. I don't know much about v2 but the filament exit looks inboard so may not be a direct swap.

Estrusore Di buona fattura, unico difetto:Non è quello della descrizione, nella descrizione e nelle foto viene menzionato con tanto di datasheet ,Il motore LDE, ATTENZIONE non è così, vi arriva un MOONS, lo tengo solo perchè mi serve ma non sono soddisfatto dell’acquisto

Extruder funktioniert seit langem anstandslos!

mauvais entraxe et ne correspond pas à ma voron.j'ai du refaire une pièce avec une autre machine.sinon très bonne qualité.