Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Philips Hue Verlengkabel - Verlengsnoer: 2.5 Meter - Voor Buiten - IP67 - Eenvoudige Installatie - Verbind met Hue Bridge

10,99€ 21,59€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Breid je slimme buitenverlichting uit met de Philips Hue voedingskabel van 2,5 meter en het T-verlengstuk en vergroot de afstand tussen de voeding en je eerste lichtpunt
  • Deze Philips Hue verlengkabel werkt op laagspanning en is speciaal ontworpen voor buiten en rigoureus getest voor optimale prestaties, met een beschermingsgraad van IP67
  • Door de T-vorm van het verlengstuk kunt u hiermee ook hoekjes om en is de installatie altijd zonder problemen te doen; waar u uw slimme lampen ook wilt plaatsen, het T-verlengstuk maakt het dus een stuk gemakkelijker
  • De totale maximale systeemlengte per voeding is 35 meter
  • Als je wil genieten van alle mogelijkheden van dit artikel, heb je een Philips Hue Bridge nodig waarmee je deze bewegingssensor toevoegt aan je slimme Philips Hue verlichtingssysteem


Productbeschrijving


De video toont het product dat in gebruik is.De video begeleidt u bij het instellen van het product.In de video worden meerdere producten vergeleken.De video toont hoe het product wordt uitgepakt.

hero-video

Video van merchant
Philips Hue
Philips Hue
Philips Hue

Scribblygum
8 augustus 2025
Worth any extra money you pay for Philips hue. Top quality, long lasting products that are consistently well made & tested
AP
19 juli 2025
Ideal
P. JF
27 april 2025
très bien
694X
18 maart 2025
Bought this to connect a Hue Outdoor Lightstrip located outside to its power supply located in the garage.The problem with the Outdoor Lightstrip is that everything is hard-wired up to the relatively bulky waterproof connector for the DC low-voltage side of the transformer. I didn't fancy cutting up the expensive Outdoor Lightstrip (either the RGBW cable between the controller and the strip, or the DC cable from the controller to the connector), but also didn't want to drill a 1-inch hole through my wall to feed the waterproof connector through.This solved the problem.The complete lightstrip sits outside (i.e. strip, RGB cable, controller, DC cable, connector). I then cut this extension cable in half to feed just the cut cable through the wall, before splicing back together in the garage where water-tightness isn't essential. It's just a 2-core cable carrying low voltage DC power, so a very simply DIY job.
Deirdre Laird
9 december 2024
This cable allows you to connect outdoor lights closer together!