WINGONEER USB 2.0 naar RS485 Serieel Converter Adapter CP2104 SN75176 dubbele bescherming FUSE + TVS stabieler dan FT232

Ok

I used the Wingoneeer CP2104 Serial Converter, USB 2.0 To TTL UART, 6 PIN Module, to communicate between a Jameco bare bones Arduino circuit kit and the Arduino IDE on the PC and it worked perfectly!The Jameco kit included the ATMega328P-PU 32kB Flash microcontroller with pre-loaded Arduino UNO Optiboot bootloader. All I need was a way to get sketches downloaded from the PC to the bare bones kit IC. The Jameco kit documentation used FTDI's basic breakout board for USB to serial but I would recommend using the less expensive CP2104 Wingoneer. Jameco suggested using a 0.1uF ceramic capacitor (included in the bare bones kit) between the DTR line and the reset pin on the 328Amega chip. This "hack" was also mentioned in another review.Link to Jameco kit:On this kit it was necessary to disconnect the 3VDC & 5VDC power regulators from the voltage source while powering the Jameco kit from the USB and Wingoneer UART. The RXD & TXD are reversed when connecting them to the kit IC, pins 2 & 3. The Windows 10 drivers loaded automatically. Downloading sketches through the USB/CP2104 worked fine using the UNO board identification. The picture shows the CP2104 being powered by the USB and running the kit. The sketch program flashes the (3) red LED's and then the (3) green LED's. Note the 0.1uF capacitor between DTR (CP2104 brown wire) and chip pin #1 (reset).

Plugged into my Windows 10 machine and was recognised straight away. Ran Putty with tx/rx loopback - echo worked straight away. Far better than the cheaper FTDI232 I got from another supplier where the header pins didn't want to work - probably why it was cheaper - but then this isn't expensive (wish I'd bought it first)It has 5v and 3.3v pins - I use it for programming some STM32 devices - they happen to be 5v tolerant on the RX/TX pins but some devices need only 3.3v so this will work with either. It was delivered with a cable as per picture.However, if, like me, you spread your electronics about on your desk then you need to get a USB A male to female extender OR a longer 6 way extension (harder to find). I did find some 50cm jumper wires from sourcingmap on Amazon - they would help.

Perfecto, lo he usado con w10 pro, hay que descargar primero los drivers de la página del fabricante, funciona muy bien, he sacado las configuraciones del router con ont integrado y de la nueva ont, que éra de 2a mano, todo ello para poder utilizar mi propio router, y ya está todo perfecto y configurado, el envio, como siempre muy rápido, los programas que se pueden usar, entrevotrosson PUTTY y SECURECRT.

utilizzato per un Oppo 203 per forzare un firmware russo ottima resa poca spesa